|
Purification Unit
|
|
|
|
|
|
|
|
|
|
|
Serial No: A076
Vac: 115
HZ: 60
PH: 1
The portable fluid purifier is designed to remove water, air, chlorinated solvents and solid contaminants from lubricating, hydraulic, and heat transfer fluids. The purifier itself is a portable system requiring only an open space close to the contaminated fluid reservoir, aircraft, or equipment to be cleaned and purified and ready access to the required electrical power.
The Pall unit would be good wherever there are large Hydraulic Systems, especially presses or manufacturing environments that usually produce contamination into large Hydraulic Systems.
The following table lists the specifications applicable to the purifier.
Fluid Type Hydraulic lubricating & heat transfer oils compatible with Buna-N having a flash point off 200° F per ASTMD92 or below 180º F per ASTMD93.
Inlet Fluid Temp +145º F (62º C)
Operation Viscosity Up to 1300 SSU
Vacuum Chamber Operating Vac 24" Hg ± 2" Hg
Inlet Y-Strainer Filtration 100 Mesh
Discharge Filter Element Rating: 3 micron abs. with a gravimetric efficiency of 99.5% min. when tested per
Mil-F-81836
Inlet Pressure (max.) +20 PSIG
Inlet Pressure (min.) -10" Hg
Volts 120
AMPS 15
KW Max 20
Hose Connection REQ'MTS Inlet -1" ID min. Inlet hose should be rated for -16 hose suction & hose return line SVC. per SAE 100R4; Outlet ¾ ID min. Note: Connecting -12 hose to be furnished by customer.
Elect. Power Connection REQ'MTS The elec. receptacle must conform to NEMA 5-15R. Recommended line fuse or circuit breaker size is 15 AMPS.
Manual is available.
|
|
|
|
|
|
Units
Subject To Prior Sale
Copyright 1999 American
Lab and Systems, U.S.A.
All Rights Reserved. No portion of this site
may be copied, retransmitted, reposted, duplicated
or otherwise used without the express written
permission of American Lab and Systems
|
|
|